Kingswood manor house conversion to apartments utilising the Lewis Deck for the Acoustic and fire separating floors as well as the wet-room and underfloor heating solution.
Kingswood Warren Park Mansion House conversion

Kingswood Warren Park Mansion House conversion

Conversion to apartments by Octagon Homes

The conversion of the Listed Mansion House on the Kingswood Manor estate in Surrey required very high performing acoustic floors for these very high quality apartments, the floors also needed to cope with the use of large format tiles, including marble without the danger of any deflection and cracking.  This was achieved using the Lewis Deck system for all of the floors, but included the wet-room bath rooms and the incorporation of under floor heating throughout.

Marble floors over Lewis Deck and screed with underfloor heating
Marble floors over Lewis Deck and screed with underfloor heating

The Lewis Deck with resilient strips underneath was installed over the existing timber floor to provide very high levels of both airborne and impact sound protection to the apartments below, this includes the low frequency noise associated with footfall, etc and can be particularly troublesome with light weight floor constructions and hard floor coverings.

Underfloor heating pipes were secured to the top of the Lewis Deck with clip-rails and P-clips before the installation of the free-flowing liquid screed.

The mansion house won the 2014 Best Change of Use of an Existing Building or Conversion Award at the LABC Awards.

www.hubarchitects.co.uk/Blog/kingswood-wins-award/

Large format marble tiles in a wet-room bathroom with underfloor heating upstairs on Lewis Deck
Large format marble tiles in a wet-room bathroom with underfloor heating upstairs on Lewis Deck

LEWIS DECK TO CREATE WET ROOM FLOORS

Lewis Dovetailed Sheeting is ideal for creating wet-room floors in either existing or new build construction. The sheet can be used instead of timber boards to span over the joists to produce a waterproof, lightweight reinforced concrete floor that allows for tiles to be laid with no fear of cracking or moving. Alternatively it can be laid over the existing floorboards.

This is an accepted wet-room floor solution used extensively across Europe, especially in a number of countries where concrete bathroom floors are part of the building codes.
Wet-room floors using Lewis Deck can be as little as 36mm deep.
Each standard sheet is 2500mm x 630mm x 16mm and weighs 9kg, alternatively we stock a 1300mm x 630mm x 16mm sized sheet that can be supplied in small numbers using TNT for smaller bathrooms.

FAQs

Ask CDI a Question

  • Q

    Do I keep my joist centres at 400mm when using Lewis Deck?

    A

    One of the great things about using Lewis Deck is that it opens up a number of different options for you and one of them is around joist centres you can work with.

    Traditionally we see the vast majority of architects and designers insisting that timber joists be installed at either 400mm or at most 600mm because this is the limit of what timber floor systems will effectively span to. Now with Lewis, because of its unique profile (with the dovetails dimensions) and the way it interacts with the thin (50mm) screed laid on it, you can actually go much wider than these figures. With a 50mm screed, on top of the sheets, Lewis allows you to have unpropped centres of up to 1200mm (1.2m). Even at these much wider centres Lewis will allow you to have a permissible load of 14.8kN/m2, which in English is just under 1.5 Tonnes per m2. Now this might sound fantastic, and it is, but in reality for 95% of new build homes this figure won't really make too much difference to what you were planning on doing with upstairs. What it does mean though is that at your normal centres, of approximately 600mm, your floor becomes so much stronger than traditional forms of floor structure that it allows you to do things on the 1st floor that you take for granted on the ground floor. First of all is the obvious one, you get a solid floor, meaning no more squeaky floor boards or hearing people walking around upstairs and knowing exactly where they are up there! Having the solid floor gives you the chance to have a very efficient underfloor heating system (see our applications section for more details) which in most cases will probably mean a slight reduction in your fuel bills. Other big benefits of having a stronger floor upstairs include being able to have either thinner tiles or much heavier tiles than you can use on timber floor systems. The screed and Lewis working together pretty much stops any deflection in the floor meaning that these types of tiles won't crack or move and lift over time as the floor doesn't move or deflect! So in conclusion yes you can have much wider joist centres than the 400mm centres that you normally see on new developments but even if you wanted to keep them the same by using Lewis Deck it opens up so many benefits that you just aren't able to incorporate with traditional timber floor systems. However the joist centres are usually controlled by the load capacity of the joist and not the spanning capacity of the Lewis Deck.

    Q

    Do you fix Lewis Deck down to the joists?

    A

    The short answer to this is no Lewis Deck doesn't have to be fixed down.

    Generally the reason why people choose to use Lewis Deck over more traditional floor systems is that they are looking to enhance the upper floor that they are working on. So if you are going to be looking at using Lewis then you might as well look to incorporate its full range of benefits. One of which is the major uplift in acoustic performance that you get from using the system. Getting the best results, acoustically, is achieved by laying the floor as a floating floor. This then creates separation between the supporting floor joists and and the steel deck. To enhance this further introduce a resilient strip on top of the joist. See below. [caption id="attachment_559" align="alignnone" width="300"]Lewis Metal Dovetailed Sheeting Deck with acoustic Sylomer resilient strips Lewis Metal Dovetailed Sheeting Deck with acoustic Sylomer resilient strips[/caption] When it comes to determining which of our acoustic resilient strips to use (because we have a few of them and they all do different jobs depending on the use of them and the type of structure below) we are happy to help you come up with the correct option that suits your project the best. A standard Lewis Deck floor detail (such as the detail above) easily achieves UK requirements for acoustic (as well as fire) resistance for residential separating floors. Higher performance standards are easily achievable too. Because of this we have seen Lewis Deck used frequently in in bespoke projects such as live music/ theatre venues, cinemas, recording studios, specialist test labs, plant room floors and many other commercial applications. Note: some joists my require lateral stability and therefore lateral restraint straps or timber noggins or a sacrificial timber board may be required to achieve this, your joist supplier or designer will be able to provide this information, in some cases the Lewis Deck can be fixed down to provide this action if required. Please feel free to give us a call and discuss this further should you wish to do so.

    Q

    Lacomet – How come it has no scrap value?

    A

    Lacomet – How come it has no scrap value? Many of the projects that we get involved in starts with a phone call or email to us from someone researching replacing stolen leadwork. Many of these are old buildings, such as schools or churches, where this isn’t the first time that the lead has been stolen and they call us fed up with having to replace it again full in the knowledge that they will more than likely go through the same problem once more in the near future if they continue to use lead. One of the big benefits that Lacomet FL brings to a project is the fact that it has no scrap value and therefore the chances of it being stolen are massively reduced. Due to the 2 thin aluminium layers, and its five layer total construction, it is of no value to thieves. Lacomet can be recycled but the polyester based coating would need to be de-laminated first and the amount of recovered aluminum is then very low, in fact it would be easier and more profitable to collect empty drinks cans than to mess about stripping Lacomet down. We can also supply stickers that can be placed in strategic locations informing people that what is now on the roof is not lead and that it has no scrap value.

  • Q

    Do you fix Lewis Deck down to the joists?

    A

    The short answer to this is no Lewis Deck doesn't have to be fixed down.

    Generally the reason why people choose to use Lewis Deck over more traditional floor systems is that they are looking to enhance the upper floor that they are working on. So if you are going to be looking at using Lewis then you might as well look to incorporate its full range of benefits. One of which is the major uplift in acoustic performance that you get from using the system. Getting the best results, acoustically, is achieved by laying the floor as a floating floor. This then creates separation between the supporting floor joists and and the steel deck. To enhance this further introduce a resilient strip on top of the joist. See below. [caption id="attachment_559" align="alignnone" width="300"]Lewis Metal Dovetailed Sheeting Deck with acoustic Sylomer resilient strips Lewis Metal Dovetailed Sheeting Deck with acoustic Sylomer resilient strips[/caption] When it comes to determining which of our acoustic resilient strips to use (because we have a few of them and they all do different jobs depending on the use of them and the type of structure below) we are happy to help you come up with the correct option that suits your project the best. A standard Lewis Deck floor detail (such as the detail above) easily achieves UK requirements for acoustic (as well as fire) resistance for residential separating floors. Higher performance standards are easily achievable too. Because of this we have seen Lewis Deck used frequently in in bespoke projects such as live music/ theatre venues, cinemas, recording studios, specialist test labs, plant room floors and many other commercial applications. Note: some joists my require lateral stability and therefore lateral restraint straps or timber noggins or a sacrificial timber board may be required to achieve this, your joist supplier or designer will be able to provide this information, in some cases the Lewis Deck can be fixed down to provide this action if required. Please feel free to give us a call and discuss this further should you wish to do so.

    Q

    Lacomet – How come it has no scrap value?

    A

    Lacomet – How come it has no scrap value? Many of the projects that we get involved in starts with a phone call or email to us from someone researching replacing stolen leadwork. Many of these are old buildings, such as schools or churches, where this isn’t the first time that the lead has been stolen and they call us fed up with having to replace it again full in the knowledge that they will more than likely go through the same problem once more in the near future if they continue to use lead. One of the big benefits that Lacomet FL brings to a project is the fact that it has no scrap value and therefore the chances of it being stolen are massively reduced. Due to the 2 thin aluminium layers, and its five layer total construction, it is of no value to thieves. Lacomet can be recycled but the polyester based coating would need to be de-laminated first and the amount of recovered aluminum is then very low, in fact it would be easier and more profitable to collect empty drinks cans than to mess about stripping Lacomet down. We can also supply stickers that can be placed in strategic locations informing people that what is now on the roof is not lead and that it has no scrap value.

Ask CDI a Question

Latest Blog

CDI 2017

Granite tiles and shower tray laid over a Lewis Deck and Concrete floor upstairs over timber joists

Travertine wetroom by Craig Bills

30th May 2017

Craig Bills is a master tiler and has been installing wet-rooms using Lewis Deck and concrete for over 20 years, he is a passionate advocate for the Lewis Deck system in wet-rooms and bathrooms as it give an opportunity for the floor to be 1 piece of waterproofed concrete.  This makes a very robust and …

Read more

We've a new model down at Swindon!

18th May 2017

One of the great benefits that you get from introducing Lewis Deck into a residential development is the option to install a wet room floor into bathroom/ en-suite areas with extreme ease compared to other flooring systems as well as maintaining one solid concrete slab in the room reducing the possibility of leaks from a …

Read more

Chat Live

Hi your speaking to Dave, how can I help.